Isuzu 2008MY N Series, Руководство по ремонту

Страница: 59 / 404

1A-56 Engine Control System (4HK1)
6
Notice: If no airbag system installed, skip to Step
7.
Does the scan tool communicate SRS control
unit?
—
Go to Step 7
Go to Diagnostic
System Check -
SRS Controls in
Section 8C SRS
Control System
7
Notice: If no immobilizer system installed, skip to
Step 8.
Does the scan tool communicate SRS control
unit?
—
Go to Step 8
Go to Diagnostic
System Check -
Immobilizer
Controls in Section
9I Security and Lock
8
Test the Keyword serial data circuit for an
intermittently short to ground or intermittently short
to voltage. Then, test the Keyword serial data
circuit for an intermittently open (based on which
control module did not communicate) at the
connection in the circuit.
Did you find and correct the condition?
—
Go to Step 21 System OK
9
1. Inspect for an intermittent, for a poor
connection and for corrosion at the data link
connector (DLC) (pin 7 of B-31).
2. Repair the connection(s) as necessary.
Did you find and correct the condition?
—
Go to Step 21 Go to Step 10
10
1. Turn OFF the ignition.
2. Disconnect the ECM E-12 and J-14 harness
connectors.
3. Turn ON the ignition, with the engine OFF.
4. Attempt to communicate with the TCM, HSA
control unit and SRS control unit.
Does the scan tool communicate with the
TCM, ICU, HSA control unit and SRS control
unit?
—
Go to Step 16 Go to Step 11
11
Notice: If no Smoother transmission is installed,
skip to Step 12.
1.
Turn OFF the ignition,
2. Reconnect the ECM E-12 and J-14 harness
connectors.
3. Disconnect the TCM B-109, B-110, B-111 and
B-112 harness connectors.
4. Turn ON the ignition, with the engine OFF.
5. Attempt to communicate with the ECM, HSA
control unit and SRS control unit.
Does the scan tool communicate with the
ECM, ICU, HSA control unit and SRS control
unit?
—
Go to Step 17 Go to Step 12
Step Action Value(s) Yes No
LG4HKED-WE-0871.book 56 ページ ２００７年１１月２９日 木曜日 午後６時２９分