Isuzu 2008MY N Series, Руководство по ремонту

Страница: 300 / 404

Engine Control System (4HK1) 1A-297
4
1. Turn OFF the ignition.
2. Disconnect the exhaust differential pressure
sensor harness connector.
3. Inspect for an intermittent, for poor
connections and corrosion at the harness
connector of the exhaust differential pressure
sensor (pins 1, 2 and 3 of J-33).
4. Disconnect the ECM harness connector.
5. Inspect for an intermittent, for poor
connections and corrosion at the harness
connector of the ECM (pins 67, 79 and 80 of
J-14).
6. Repair the connection(s) as necessary.
Did you find and correct the condition?
—
Go to Step 7 Go to Step 5
5
1. Test each sensor circuit between the ECM
(pins 67, 79 and 80 of J-14) and the exhaust
differential pressure sensor (pins 1, 2 and 3 of
J-33) for high resistance.
2. Repair the circuit(s) as necessary.
Did you find and correct the condition?
—
Go to Step 7 Go to Step 6
6
Important: Replacement exhaust differential
pressure sensor must be learned.
Replace the exhaust differential pressure sensor.
Refer to Exhaust Differential Pressure Sensor in
Section 1G Engine Exhaust.
Did you complete the replacement?
—
Go to Step 7
—
7
1. Reconnect all previously disconnected
harness connector(s).
2. Clear the DTCs with a scan tool.
3. Turn OFF the ignition for 30 seconds.
4. Turn ON the ignition for 30 seconds while
observing the DTC Information with a scan
tool.
Did the DTC fail this ignition?
—
Go to Step 2 Go to Step 8
8
Observe the DTC Information with a scan tool.
Are there any DTCs that you have not
diagnosed?
—
Go to DTC List System OK
Step Action Value(s) Yes No
LG4HKED-WE-0871.book 297 ページ ２００７年１１月２９日 木曜日 午後６時２９分