Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1314 / 2459

＋ −
＋ −
−
−
−
＋ −
−
− ＋ −
＋ −
−
−
−
＋ −
＋ −
＋ −
＋ −
０３
Ｓ０Ｘ４Ａ０６Ｋ７０２０００８１１２０ＦＡＡＴ００
＋ −
＋
−
＋
−
＋
−
DTC Appropriate Terminal
( ) Side ( ) Side
YES
NO
YES
NO
DTC Appropriate Wheel Sensor
YES
NO
ABS DTC 12, 14, 16, 18:
19-113 19-113
ABS/TCS CONTROL UNIT CONNECTOR A (26P)
FLW ( ) (GRN/BLU) FRW ( ) (GRN)
FRW ( )
(GRN/BLK)
FLW ( ) (BRN)
RLW ( )
(LT BLU)
RLW ( ) (GRY)
RRW ( )
(GRN/YEL)
RRW ( )
(BLU/YEL)
6. Check the resistance between the appropriate
wheel sensor ( ) and ( ) circuit terminals (see
table).
11 (Right-front) No. 11 : No. 10 :
13 (Left-front) No. 9 : No. 8 :
15 (Right-rear) No. 23 : No. 24 :
17 (Left-rear) No. 21 : No. 22 :
Check for loose ABS/TCS control unit
connectors. If necessary, substitute a known-good
ABS/TCS control unit, and recheck.
Go to step 7.
7. Disconnect the harness 2P connector from the
appropriate wheel sensor, and check the resistance
between the (
) and ( ) terminals of the wheel
sensor.
Repair open in the ( ) or ( ) circuit wire, or
short between the ( ) circuit wire and the ( )
circuit wire between the ABS/TCS control unit and
the wheel sensor.
Replace the wheel sensor.
NOTE: If the ABS indicator comes on because of
electrical noise, the indicator goes off when you test-
drive the vehicle at 19 mph (30 km/h).
1. Visually check for appropriate wheel sensor and
pulser installation (see table).
12 Right-front
14 Left-front
16 Right-rear
18 Left-rear
Go to step 2.
Reinstall or replace the appropriate wheel
sensor or pulser.
2. Disconnect the ABS/TCS control unit connector A
(26P).
(cont’d)
FRW ( ) FRW ( )
FLW ( ) FLW ( )
RRW ( ) RRW ( )
RLW ( ) RLW ( )
Wheel Sensor
(Electrical Noise/Intermittent Interruption)
Wire side of female terminals
Is the r esistance between 450 2,000 ?
Is the r esistance between 450 2,000 ?
Ar e they installed cor r ectly?
03/07/29 09:57:34 61S0X050_190_0113