Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1228 / 2459

− −
＊０１
＊０２
Ｓ０Ｘ４ＡＺＡＤ１４３０００１４７２１ＭＡＡＴ２０
’02-04 Models
Runout
Thickness and Parallelism
Brake Disc Runout:
Service Limit: 0.10 mm (0.004 in.)
Max. Refinish Limit: 9.0 mm (0.35 in.)
Brake Disc Thickness:
Standard: 10.9 11.1 mm (0.43 0.44 in.)
Max. Refinishing Limit: 9.0 mm (0.35 in.)
Brake Disc Parallelism:
0.015 mm (0.0006 in.) max.
19-27
Rear Brake Disc Inspection
10 mm (0.4 in.)
A
108 N·m
(11.0 kgf·m, 79.6 lbf·ft)
10 mm (0.4 in.)
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15). Remove the rear wheels.
2. Remove the brake pads (see page 19-25).
3. Inspect the brake disc surface for damage and
cracks. Clean the disc thoroughly, and remove all
rust.
4. Install suitable flat washers (A) and wheel nuts, and
tighten the nuts to the specified torque to hold the
brake disc securely against the hub.
5. Set up the dial gauge against the brake disc as
shown, and measure the runout at 10 mm (0.4 in.)
from the outer edge of the brake disc.
6. If the brake disc is beyond the service limit, refinish
the brake disc.
NOTE:
• If the brake disc is beyond the service limit for
• A new disc should be refinished if its runout is
greater than 0.10 mm (0.004 in.).
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15). Remove the rear wheels.
2. Remove the brake pads (see page 19-25).
3. Using a micrometer, measure disc thickness at
eight points, about 45° apart and 10 mm (0.4 in.) in
from the outer edge of the brake disc. Replace the
brake disc if the smallest measurement is less than
the max. refinishing limit.
NOTE: This is the maximum allowable difference
between the thickness measurements.
4. If the brake disc is beyond the service limit for
parallelism, refinish the brake disc.
NOTE: If the brake disc is beyond the service limit
03/07/29 09:54:04 61S0X050_190_0027
refinishing, replace it (see step 8 page 18-24).
for refinishing, replace it (see step 8 on page 18-24).