Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 591 / 2459

−
−
−
−
−
−
−
０４
０１
Ｓ０Ｘ４ＡＺ０Ｋ７７１０００９１４５７ＦＡＡＴ００
Vacuum Hoses and Connections Test
YES
NO
YES
NO
Special Tools Required
EVAP Purge Control Solenoid Valve Test
DTC P1457 ’99-00 Models:
11-282 11-282
EVAP System
DTC Troubleshooting (cont’d)
D
G
F
B
C
A
E
I
H
J
A973X-
041-XXXXX
A
30. Do the fuel tank vapor control valve test (see page
11-298).
Go to step 31.
Replace the fuel tank vapor control valve.
31. Tighten the fuel cap 3 ‘‘clicks’’, then monitor the
fuel tank pressure readings with the HDS.
32. Start the engine. Let the engine idle for 5 minutes.
33. Check the FTP sensor readings.
Substitute a known-good PCM and retest
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
Check these parts for leaks:
• Fuel tank (A)
• Fuel fill cap (B)
• Fuel fill pipe (C)
• Fuel tank vapor control valve (D)
• Fuel tank vapor recirculation valve (E)
• Fuel tank vapor recirculation tube (F)
• Fuel tank vapor signal tube (G)
• Fuel tank vapor vent tube (H)
• EVAP two way valve (I)
• FTP sensor (J)
– Repair or replace any leaking parts.
The fuel system is designed to allow specified
maximum vacuum and pressure conditions. Do not
deviate from the vacuum and pressure tests as
indicated in these procedures. Excessive pressure/
vacuum would damage the EVAP components or cause
eventual fuel tank system failure.
Vacuum pump/gauge, 0 30 in.Hg A973X-041-XXXXX
NOTE: If DTC P0461 is stored at the same time as
DTC P1457, troubleshoot P0461 first, then recheck for
DTC P1457.
This is a two trip code; once cleared, it cannot be
reproduced in one trip. Also, certain specific driving
and ambient conditions must occur before the PCM will
complete the system checks. Additional test drives may
still not meet the specific conditions needed to
reproduce the code.
Follow these troubleshooting procedures carefully to
ensure the integrity of the system and to confirm the
cause of the problem or code.
NOTE: Fresh fuel has a high volatility that creates
greater pressure/vacuum. The optimum condition for
testing is fresh fuel, and there must be less than a full
tank of fuel. If possible, to assist in leak detection, add
one gallon of fresh fuel to the tank (as long as it will not
fill the tank), just before starting these procedures.
1. Disconnect the vacuum hose from the EVAP purge
control solenoid valve (A), and connect a vacuum
pump to the hose.
EVAP Control
System Leakage (EVAP canister system)
Is the f uel tank vapor contr ol valve OK ?
Is the r eading above 0.5 kPa ( 0.16 in.Hg, 4 mmHg)
pr essur e or below
0.5 kPa ( 0.16 in.Hg, 4 mmHg)
vacuum?
03/07/29 09:26:15 61S0X050_110_0282