Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1675 / 2459

０１
Ｓ０Ｘ４Ａ１２Ｇ４４２２３７０００００ＫＢＡＴ００
21-144
Rear Heater-A/C
Rear Evaporator-Heater Unit Component Replacement
F E
D
H
J
I
G
K
L
C
B A
NOTE:
• The rear mode control motor can be replaced without removing the rear evaporator-heater unit.
• Replace all O-rings, and coat them with refrigerant oil before installation.
• Install the capillary tube (K) directly against the outlet line, and wrap it with electrical tape (L).
• Before reassembly, make sure that the rear mode control doors and linkage move smoothly without binding.
• After reassembly, make sure the rear mode control motor runs smoothly (see page 21-139).
• Make sure that there is no coolant leakage.
• Make sure that there is no air leakage.
1. Remove the self-tapping screws and the clamp (A), then remove the bolts and the evaporator lines (B) together
with the expansion valve (C). If necessary, remove the expansion valve. Use a second wrench to hold the other
fitting on the valve so the evaporator lines won’t twist. Leave the first fitting loosely connected so you can use it to
hold the valve while you loosen the second fitting.
2. Remove the self-tapping screws and the clamp (D), then be careful not to bend the inlet and outlet pipes during
the heater core (E) removal, and pull out the heater core.
3. Remove the self-tapping screws and the rear mode control motor (F).
4. Remove the self-tapping screws and the lower housing (G).
5. Remove the self-tapping screws, carefully separate the right housing (H) from the left housing (I), then remove the
evaporator core (J).
6. Reassemble the unit in the reverse order of disassembly.
03/07/29 10:14:36 61S0X050_210_0145