Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1190 / 2459

＊０２ ０３
０４
REAR DRUM BRAKE TYPE: ’99-01 models
18-23
C
B
A
12 x 1.5 mm
108 N·m (11.0 kgf·m,
79.6 lbf·ft)
D
24 x 1.5 mm
245 N·m (25.0 kgf·m,
181 lbf·ft)
8 x 1.25 mm
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15).
2. Remove the wheel nuts (A) and rear wheel (B).
3. Press the parking brake pedal.
4. Remove the hub cap (C).
5. Raise the locking tab on the spindle nut (D), then
remove the nut.
6. Release the parking brake pedal.
7. Screw two 8 x 1.25 mm bolts into the drum to push
it away from the hub bearing unit. Turn each bolt
two turns at a time to prevent cocking the brake
drum excessively. Remove the brake drum from
the hub bearing unit. If the drum does not come off
easily, back off the brake adjuster one full turn
(23 teeth).
8. Remove the hub bearing unit.
9. Install the hub bearing unit in the reverse order of
removal, and pay particular attention to the
following items:
• Wash the bearing and spindle thoroughly in high
flash point solvent before reassembly.
• Before installing the new spindle nut, apply a
small amount of engine oil to the seating surface
of the nut.
• After tightening, use a drift to stake the spindle
nut shoulder against the spindle.
• Inspect the pulser teeth for any damage.
(cont’d)
03/07/29 09:51:17 61S0X050_180_0023