Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1062 / 2459

− −
＊０１
＊０２
Ｓ０Ｘ４ＡＡ１Ｅ１０４１１３０００００ＭＡＡＴ００
Standard: 0.07 0.15 mm (0.003 0.006 in.)
SPLINED WASHER, 38 x 56.5 mm
No. Part Number Thickness
14-449
Secondary Shaft Clearance Inspection
I
A
B
C
D
E
F
G
H
J
F
E
B
J
1. Remove the O-rings from the secondary shaft.
2. Assemble the thrust needle bearing (A), 1st gear
assembly (B), needle bearings (C), thrust needle
bearing (D), 38 x 56.5 mm splined washer (E), 32
mm cotters (F), cotter retainer (G), and snap ring (H)
on the secondary shaft (I).
3. Measure the clearance between the 38 x 56.5 mm
splined washer (E) and 32 mm cotters (F) with a
feeler gauge (J) in at least three places. Use the
average as the actual clearance.
4. If the measurement is out of standard, remove the
splined washer, and measure its thickness.
5. Select and install a new splined washer, then
recheck the clearance.
1 90502-P0Z-000 6.85 mm (0.270 in.)
2 90503-P0Z-000 6.90 mm (0.272 in.)
3 90504-P0Z-000 6.95 mm (0.274 in.)
4 90505-P0Z-000 7.00 mm (0.276 in.)
5 90506-P0Z-000 7.05 mm (0.278 in.)
6 90507-P0Z-000 7.10 mm (0.280 in.)
(cont’d)
03/07/29 09:46:02 61S0X050_140_0452