Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1284 / 2459

＊０６
＊０３
＊０４
How to Clear ABS DTCs
HDS (Honda Diagnostic System) Method
Service Check Signal (SCS) Circuit Method
19-83
Example of DTC 15
ON
OFF
Long blink
Short blinks
(5 times)
ON
OFF
Example of DTC 22
Long blinks (2 times)
Short blinks
(2 times)
A
A
4. The blinking frequency indicates the DTC. DTCs are
indicated by a series of long and short blinks. One
long blink equals 10 short blinks. Add the long and
short blinks together to determine the DTC. After
determining the DTC, refer to the DTC
Troubleshooting Index.
NOTE: If the DTC is not memorized, the ABS or TCS
indicator will go off for 3.6 seconds, and then come
back on.
The system will not indicate the DTC unless these
conditions are met:
• The TCS switch is not pushed.
• The brake pedal is not pressed.
• The ignition switch is turned ON (II).
• The engine is stopped.
• The SCS circuit is shorted to body ground before
the ignition switch is turned ON (II).
5. Turn the ignition switch OFF.
6. Disconnect the HDS from the DLC.
1. With the ignition switch OFF, connect the HDS to
the 16P Data Link Connector (DLC) (A) under the
driver’s side of the dashboard.
2. Turn the ignition switch ON (II), and clear the
DTC(s) by following the screen prompts on the HDS.
NOTE: See the HDS help menu for specific
instructions.
1. With the ignition switch OFF, connect the HDS to
the 16P Data Link Connector (DLC) (A) under the
driver’s side of the dashboard.
2. Short the SCS circuit to body ground using the HDS.
(cont’d)
03/07/29 09:56:03 61S0X050_190_0083