Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 444 / 2459

−
−
−
−
−
−
−
−
＊０１
＊０２
YES
NO
YES
NO
YES
NO
YES
NO
11-135
IGNITION COIL 3P CONNECTOR
IG
(BLK/YEL)
IGNITION COIL 3P CONNECTOR
GND
(BLK)
14. Turn the ignition switch OFF.
15. Exchange the injector from the problem cylinder
with one from another cylinder.
16. Let the engine idle for 2 minutes.
17. Test-drive the vehicle several times in the range of
the freeze data or under various conditions if there
was no freeze data.
18. Check for a DTC or a Temporary DTC with the scan
tool or the HDS.
Go to step 19.
Intermittent misfire due to bad contact in the
injector connector (no misfire at this time). Check
for poor connections or loose terminals at the
injector.
19. Determine which cylinder had the misfire.
Replace the faulty injector
(see page 11-177).
Go to step 20.
20. Turn the ignition switch OFF.
21. Disconnect the ignition coil 3P connector from the
problem cylinder.
22. Turn the ignition switch ON (II).
23. Measure voltage between ignition coil 3P
connector terminal No. 3 and body ground.
Go to step 24.
Repair open or short in the wire between the
No. 11 COIL (No. 7 on ’02-04 models) (15A) fuse
and the ignition coil.
24. Turn the ignition switch OFF.
25. Check for continuity between ignition coil 3P
connector terminal No. 2 and body ground.
Go to step 26.
Repair open in the wire between the ignition
coil and G101 (or G102).
26. Disconnect PCM connector C (31P).
(cont’d)
Wire side of
female terminals
Wire side of
female terminals
Is DT C P0301, P0302, P0303, P0304, P0305, or
P0306, or T empor ar y DT C P1399 indicated?
Does the misf ir e occur in the cylinder wher e the
injector was exchanged?
Is ther e batter y voltage?
Is ther e continuity?
03/07/29 09:21:25 61S0X050_110_0135