Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1205 / 2459

Ｓ０Ｘ４Ａ００Ｄ１４３００００００００ＦＡＡＴ００
Component Inspections:
Component Procedure Also check for:
Brake pedal sinks/fades when braking
Brake System Test
19-4
Conventional Brake Components
Brake System Inspection and Test
•
•
•
•
•
•
•
•
•
•
Master Cylinder Look for damage or signs of fluid leakage at:
Reservoir or reservoir grommets
Line joints
Between master cylinder and booster
Brake Hoses Look for damage or signs of fluid leakage at:
Line joints and banjo bolt connections
Hoses and lines, also inspect for twisting or
damage
Bulging, twisted, or bent lines.
Caliper Look for damage or signs of fluid leakage at:
Piston seal
Banjo bolt connections
Bleeder screw
Seized or sticking caliper pins.
ABS Modulator Look for damage or signs of fluid leakage at:
Line joints
Modulator
1. Start the engine, and let it warm up to operating temperature.
2. Attach a 50 mm (2 in.) piece of masking tape along the bottom of the steering wheel, and draw a horizontal
reference mark across it.
3. With the transmission in Neutral, press and hold the brake pedal lightly (about the same pressure needed to keep
an A/T-equipped car from creeping). Then release the parking brake.
4. While still holding the brake pedal, hook the end of the tape measure behind it. Then, pull the tape up to the
steering wheel, noting where the tape measure lines up with the reference mark you made on the masking tape.
5. Apply steady pressure to the brake pedal for 3 minutes.
6. Watch the tape measure.
• If it moves less than 10 mm (0.4 in.), the master cylinder is OK.
• If it moves greater than 10 mm (0.4 in.), replace the master cylinder.
03/07/29 09:53:48 61S0X050_190_0004