Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 827 / 2459

− −
＊０１
０２
Ｓ０Ｘ４ＡＡ０Ｅ１０４１１３０００００ＭＡＡＴ００
Standard: 0.07 0.15 mm (0.003 0.006 in.)
SPLINED WASHER, 38 x 56.5 mm
No. Part Number Thickness
14-214
Shafts and Clutches
Secondary Shaft Clearance Inspection
A
B
C
D
E
F
G
H
I
J
F E
C
J
1. Remove the O-rings from the shaft.
2. Assemble the thrust needle bearing (A), needle
bearing (B), 1st gear (C), thrust needle bearing (D),
38 x 56.5 mm splined washer (E), 32 mm cotters (F),
cotter retainer (G), and snap ring (H) on the
secondary shaft (I).
3. Measure the clearance between the 38 x 56.5 mm
splined washer (E) and cotters (F) with a feeler
gauge (J) in at least three places. Use the average
as the actual clearance.
4. If the clearance is out of standard, remove the
splined washer, and measure its thickness.
5. Select and install a new splined washer, then
recheck.
1 90502-P0Z-000 6.85 mm (0.270 in.)
2 90503-P0Z-000 6.90 mm (0.272 in.)
3 90504-P0Z-000 6.95 mm (0.274 in.)
4 90505-P0Z-000 7.00 mm (0.276 in.)
5 90506-P0Z-000 7.05 mm (0.278 in.)
6 90507-P0Z-000 7.10 mm (0.280 in.)
03/07/29 09:35:31 61S0X050_140_0217