Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 740 / 2459

−
Ｓ０Ｘ４ＡＡ０Ｅ１０４７４０５９５４８ＦＥＡＴ０１
Stall Speed rpm:
Specification: 2,400 rpm
Service Limit: 2,250 2,550 rpm
Problem Probable causes
14-127
Stall Speed Test
1. Engage the parking brake, and block all four wheels.
2. Connect a tachometer to the engine, and start the
engine.
3. Make sure the A/C switch is OFF.
4. After the engine has warmed up to normal
operating temperature (the radiator fan comes on),
shift to the 2 position.
5. Fully press the brake pedal and accelerator pedal
for 6 to 8 seconds, and note the engine speed. Do
not move the shift lever while raising the engine
speed.
6. Allow 2 minutes for cooling, then repeat the test in
the D4, 1, and R positions.
NOTE:
• Do not test stall speed for more than 10 seconds
at a time.
• Stall speed tests should be used for diagnostic
purposes only.
• Stall speed should be the same in D4, 2, 1, and R
positions.
• Do not test stall speed with the A/T pressure
gauges installed.
7. If the measurements are out of the service limit,
problems and probable causes are listed in the
table below:
•
•
•
•
•
•
•
Stall speed rpm
high in the D4, 2, 1,
and R positions Low fluid level
ATF pump output low
Clogged ATF strainer
Regulator valve stuck
Slipping clutch
Stall speed rpm
high in the 1
position Slippage of 1st clutch
Stall speed rpm
high in the 2
position Slippage of 2nd clutch
Stall speed rpm
high in the R
position Slippage of 4th clutch
Stall speed low in
the D4, 2, 1, and R
positions Engine output low
Torque converter one-
way clutch slipping
03/07/29 09:32:35 61S0X050_140_0130