Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 846 / 2459

＊０８
＊０９
０１
BEARING HUB
Mark Part Number Difference
14-233
07GAB-PF50101 or
07GAB-PF50100
C
A
D
E
H
F
G
B
9. If the clearance is out of standard, remove the
bearing hub/bearing assembly using a puller as
described.
10. Select and install the new bearing hub/bearing
assembly, then recheck.
A 90520-P6H-000 3.503 mm (0.1379 in.)
B 90521-P6H-000 3.490 mm (0.1374 in.)
C 90522-P6H-000 3.477 mm (0.1369 in.)
D 90523-P6H-000 3.464 mm (0.1364 in.)
11. After replacing the bearing hub/bearing assembly,
make sure the clearance is within standard.
12. Remove the old locknut and old conical spring
washer from the countershaft.
13. Install the special tool onto the mainshaft.
14. Lubricate the following parts with ATF:
• Splines of the mainshaft, secondary shaft, and
idler gears.
• Threads of the mainshaft and secondary shaft.
• Threads of the old mainshaft and secondary shaft
locknuts.
• Old conical spring washers.
15. Install the mainshaft idler gear (A) and the old
conical spring washer (B) on the mainshaft (C).
Tighten the old locknut (D) to 226 N·m (23.0 kgf·m,
166 lbf·ft) to seat the mainshaft idler gear.
NOTE: Use a torque wrench to tighten the locknut.
Do not use an impact wrench.
16. Install the secondary shaft idler gear (E) and the old
conical spring washer (F) on the secondary shaft
(G). Tighten the old locknut (H) to 226 N·m (23.0
kgf·m, 166 lbf·ft) to seat the secondary shaft idler
gear.
NOTE:
• Use a torque wrench to tighten the locknut. Do
not use an impact wrench.
• Secondary shaft locknut has left-hand threads.
17. Remove the old locknuts and old conical spring
washers from the mainshaft and the secondary
shaft.
(cont’d)
03/07/29 09:35:47 61S0X050_140_0236