Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1196 / 2459

＊０１
＊０２
Ｓ０Ｘ４Ａ００Ｂ４４１０００５９７０１ＫＤＡＴ００
18-29
Trailing Arm Removal/Installation
C
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
B
A
12 x 1.25 mm
64 N·m
(6.5 kgf·m, 47 lbf·ft)
B
14 x 1.5 mm
103 N·m
(10.5 kgf·m, 75.9 lbf·ft)
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15).
2. Remove the brake drum or brake disc/drum.
Drum brake (see step 1 on page 18-23).
Disc brake (see step 1 on page 18-24).
3. Remove the parking brake cable (A) from the
trailing arm (B).
4. Remove the brake hose mounting bolts (C) from
the trailing arm.
5. Position a floor jack at the connecting point of the
lower arm and the knuckle.
6. Remove the flange bolts (A) and (B) from the
trailing arm.
7. Install the trailing arm in the reverse order of
removal, and note these items:
• Tighten all mounting hardware to the specified
torque values.
• Check the brake hose and line joint for leaks, and
tighten if necessary.
• Check the brake hose for interference and
twisting.
• Before installing the wheel, clean the mating
surfaces on the brake drum or the drum in brake
disc and the inside of the wheel.
• Fill up the brake reservoir, and bleed the brake
system.
• After installation, check for leaks at the line joint,
and retighten if necessary. Check the rear wheel
alignment, and adjust it if necessary (see page
18-5).
03/07/29 09:51:21 61S0X050_180_0029