Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 2105 / 2459

＊０５
０５
Initializing the OPDS (Occupant Position Detection System) Unit (’02 Model)
23-40
SRS
General Troubleshooting Information (cont’d)
C
B
07PAZ-
0010100
A
SRS indicator
MES
connector
terminals
ON
OFF
CONNECTED
DISCONNECTED
4 sec or less
Blinking
When the seat-back cover, seat-back cushion, and/or OPDS unit is replaced, initialize the OPDS system by following
the procedure.
NOTE: Make sure the passenger’s seat is dry. Set the seat-back in the normal position, and make sure there is nothing
on the front passenger’s seat.
1. Make sure the ignition switch is OFF.
2. Connect the HDS to the DLC (16P) (A), and follow the prompts in the ‘‘SCS’’ menu to ground the SCS line.
3.
4. Turn the ignition switch ON (II).
5. The SRS indicator comes on for about 6 seconds and goes off. Remove the SCS service connector from the MES
connector within 4 seconds after the SRS indicator went off.
6. The SRS indicator comes on again. Reconnect the SCS service connector to the MES connector within 4 seconds
after the SRS indicator comes on.
7. The SRS indicator goes off. Remove the SCS service connector from the MES connector within 4 seconds.
8. Watch the SRS indicator.
• If the indicator blinks two times and then stays on, the OPDS is initialized, but the DTCs need to be erased. Go to
step 9, then erase the DTCs.
• If the indicator blinks two times and then goes off, the OPDS unit is initialized. Go to step 9.
• If the indicator stays on without first blinking, the OPDS is not initialized. Read the DTC, if DTC 15-1 is indicated,
repeat the initialization procedure. If another DTC is indicated, go to the DTC Troubleshooting Index.
9. Turn the ignition switch off, and disconnect the HDS from the DLC.
03/07/29 10:31:10 61S0X050_230_0040
Connect the SCS service connector (B) to the yellow MES connector (2P) (C). Do not use a jumper wire.