Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1416 / 2459

０５
０１
０２
０３
20-51
Fastener Locations
43 mm (1.69 in.)
72 mm (2.83 in.)
51.3 mm
(2.02 in.)
55 mm
(2.17 in.)
80.2 mm (3.16 in.)
34.1 mm (1.34 in.)
C
52 mm
(2.05 in.)
73.6 mm
(2.90 in.)
B
A
A
A
A : Clip, 3 B : Clip, 1
5 mm
(0.2 in.)
: Apply primer here.
A
C
B
26.5 mm (1.04 in.)
5 mm
(0.2 in.)
A
C
B
A
C
10.5 mm
(0.413 in.)
15 mm
(0.59 in.)
10 mm
(0.39 in.)
10 mm
(0.39 in.)
8 mm
(0.3 in.)
5 mm
(0.2 in.)
10.5 mm
(0.413 in.)
11 mm (0.43 in.)
B
A
B
A
B
12 mm
(0.47 in.)
Top
5 mm (0.2 in.)
12 mm (0.47 in.)
: Apply primer here.
10 mm
(0.39 in.)
5 mm (0.2 in.)
5 mm
(0.2 in.)
10 mm
0.39 in.)
5 mm
(0.2 in.)
E
D
B
A
C
D
A
B
C
8 mm
(0.31 in.)
D
B
9. Attach the clip (A) and clip (B) with adhesive tape
(3M 4215, or equivalent) to the inside surface of the
glass (C) as shown. Be careful not to touch the
glass where adhesive will be applied.
10. Apply primer (3M C-100, or equivalent) to the
molding tape area (A) and glass primer to the
adhesive areas (B) on the inside surface of the
glass (C) as shown.
11. Apply primer to the areas (A) on each end of the
molding (B).
12. Apply adhesive to the primed areas (A) on the
inside surface of the glass, then attach the molding
(B) with adhesive tape (3M 4211, or equivalent),
and attach upper seal (C) with adhesive tape
(NITTO 501M, or equivalent) to the inside surface of
the glass (D) as shown:
• Be sure the glass and molding line up with the
lower edge, and the upper seal lines up the
alignment mark (E).
• Be careful not to touch the glass where adhesive
will be applied.
(cont’d)
03/07/29 10:01:35 61S0X050_200_0053