Honda 2004 Odyssey, Руководство по обслуживанию

Страница: 1411 / 2459

０４
＊０２
20-46
Glass
Rear Window Replacement (cont’d)
A
Fastener Locations
: Fastener, 2
A
: Fastener, 2
B
3 mm
(0.12 in.)
D
F
C
F
F
A
B
D
E
B
F
F
A
7. With a putty knife, scrape the old adhesive smooth
to a thickness of about 2 mm (0.08 in.) on the
bonding surface around the entire rear window
opening flange:
• Do not scrape down to the painted surface of the
body; damaged paint will interfere with proper
bonding.
• Remove the fasteners from the tailgate.
8. Clean the tailgate bonding surface with a sponge
dampened in alcohol. After cleaning, keep oil,
grease and water from getting on the surface.
9. If the old rear window will be reinstalled, use a
putty knife to scrape off all of the old adhesive and
rubber dam from the rear window. Clean the
shaded portion of the rear window (A) with alcohol
where new adhesive is to be applied. Make sure the
bonding surface is kept free of water, oil and
grease.
10. Attach the upper corner fasteners (A) and lower
corner fasteners (B) with adhesive tape (3M 5312,
or equivalent). Attach the upper spacer (C) and
lower rubber dam (D) with adhesive tape (NITTO
501M, or equivalent) to the inside surface of the
rear window (E) as shown:
• Be sure the fasteners, upper spacer and rubber
dam line up with alignment marks (F).
• Be careful not to touch the rear window where
adhesive will be applied.
03/07/29 10:00:29 61S0X050_200_0048