ESI ESI2000, Руководство по эксплуатации

Страница: 258 / 272

250
ESI Operation Manual
Problem: Controllers (wheels, pedal, pressure) do not work at all
and are assigned correctly.
Cause: Controllers are disabled in Realtime Control Enable
section.
Solution: Enable realtime controllers for the selected zone
(Dynamic Processing, 8. Realtime Control Enable).
Problem: The footpedal or LFO has little or no effect when
assigned to VCA.
Cause: The initial VCA level is set at 100%.
Solution: Lower the initial VCA setting as desired.
MIDI Problems
Since MIDI setups can be quite complex, make sure that you have all the
MIDI parameters (on the ESI and external MIDI devices) set correctly
before you become daunted. On the ESI, MIDI parameters are located in
the Master/Global module, (9. MIDI, 2. MIDI Globals).
Problem: The ESI does not respond to the MIDI parameters as
programmed.
Cause: MIDI Globals are turned off.
Solution: Turn on MIDI Globals (Master/Global, 9. MIDI, 2. MIDI
Globals).
Problem: The ESI does not respond to the modulation wheels or
pressure from an external MIDI controller.
Cause: MIDI controllers are not assigned in the MIDI Globals or
Realtime Control submodules.
Solution: Assign proper controller channel numbers to Left
Wheel, Right Wheel, Pedal, Pressure, MIDI A and B,
then assign MIDI A and B to desired destinations
(Master/Global, 9. MIDI, 2. MIDI Globals). Check
Realtime Control routings (Preset Definition, 0. Realtime
Controls).
Hard Disk Problems
Problem: The ESI does not recognize an external hard disk or
other SCSI device.
Cause: The external hard disk or SCSI device was powered-up
after the ESI.
Solution: Mount the drives using the Mount Drive function
located under Disk Utilities, 1 in the Master/Global
module.