ESI ESI2000, Руководство по эксплуатации

Страница: 141 / 272

Digital Processing
133
5. Move the cursor to the parameter to be selected, select the
desired value(s) with the Data Entry Control and press ENTER.
The sample will be tapered between the selected start and end points
with the type of curve selected.
• Start Amount: is the amount of gain or attenuation applied at the
start of the taper and is variable from -96 to +96 dB.
• End Amount : is the amount of gain or attenuation applied at the
end of the taper and is also variable from -96 to +96 dB.
• Type: selects the type of taper curve: Linear, Exp 1, Exp 2, Exp 3.
Graphs of these curves are shown below.
!
Caution: When using Taper Gain, avoid
clipping the signal with too much gain. The
Normalize display in the Gain Change
submodule can be used as a sample
headroom indicator.
6. If you are not satisfied with the resulting taper, or want to
compare before and after, proceed to Digital Processing, Undo
(9).
2. Gain Change
Gain Change alters the level of all or part of a sample.
1. Activate Digital Processing module.
2. Select Digital Tools I (7), Change Gain (2).
3. If the current sample is stereo, the following screen will appear.
Select the left side, right side, or both sides (stereo), then press
ENTER.
Otherwise, proceed to the next step.
CHANGE GAIN
Side: Stereo
Select L/R/Stereo
Taper Gain Curves
Exp 1
Exp 2
Exp 3
Linear
Taper Attenuation Curves
Exp 1
Exp 2
Exp 3
Linear
✱
Tip: Percussive and Plucked sounds are
notoriously hard to loop. By Taper boosting
the entire plucked sound +3 dB to +5 dB),
using the default Start and End settings, a
very natural kind of compression is applied
which makes looping these sounds much
easier.
Start with 0 dB and Taper up to +3 dB. As the
sound decays, the gain will be boosted,
leaving the attack of the sound unaffected.