ESI ESI2000, Руководство по эксплуатации

Страница: 173 / 272

Preset Definition
165
The following is a description of the footswitch destinations:
0. Off: The footswitch is not on.
1. Sustain: If you play a looped sound while the footswitch is
pressed, as soon as the looped portion begins, it will sustain (even
after lifting your fingers off the keys) until the footswitch is re-
leased. Holding down the footswitch continuously provides a hold
function for looped notes, where the last eight notes played will
sustain for as long as the footswitch is pressed. If you play an
unlooped sound while the footswitch is pressed, it will play
through its entire length (whether or not you are holding down a
key), then stop.
2. Cross-Switch: This provides footswitch-controlled switching
between the primary and secondary samples. Pressing the foot-
switch will alternate between the two samples. This function must
also be enabled under Preset Definition, 5. Crossfade/Switch.
3. Unused 1
4. Unused 2
5. Unused 3
6. Unused A
7. Unused B
8. Preset Increment: Press the footswitch to advance from one preset
to the next higher numbered preset (i.e., from preset 01 to preset
02). The ESI will stop incrementing at the highest numbered
preset.
9. Preset Decrement: Press the footswitch to fall back from one
preset to the next lower numbered preset (i.e., from preset 02 to
preset 01). The ESI will stop decrementing at the lowest numbered
preset.
5. Move the cursor to line two and repeat steps 3 and 4 to map
additional controllers.
6. Press ENTER to exit the submodule. The ESI will return to the
Module Identifier.
✱
Tip:
Preset Increment/Decrement needs
to be set for each preset if you want to step
through all your presets.
(Footswitch destinations 3-7 are EIII functions
which were not implemented in the ESI. The
numbers were retained to maintain compatibility.)