ESI ESI2000, Руководство по эксплуатации

Страница: 229 / 272

Appendix
221
MASTER EFFECT A
Effect:
Warm Hall
8. Press the Right Cursor key. The Effect Parameters screen will
appear. Set the effects parameters to your preference.
MASTER EFFECT A
Decay Time: 40
HF Damping: 64
FxB==>FxA: 0
9. Press the Right Cursor key again to go to the Effect Sends screen.
Set the Effect Send amounts to your preference.
MASTER EFFECT A
Sends:
Main: 20% Sub2: 0%
Sub1: 0% Sub3: 0%
10. If you want to adjust the Effect B settings, press the Escape key to
go back to the main Effects screen. Select Master Effect B (1) and
adjust just as you did for the “A” effect.
11. Press Enter to save the system.
þ To Assign MIDI Channels to the Main Output or to a Submix Bus
In Multimode each MIDI channel can be assigned to the main
outputs or to one of the submix busses.
If a plug is inserted into a Sub
Output jack, the dry signal from that bus is removed from the effects
processor. This feature allows you to have three dry mixes from the Sub
Outputs and an “Effects Only”␣ mix from the Main Outputs.
This lets you to program a different effect amount for several presets
using the same effect. For example, you might want just a touch of
reverb on the piano and more on the drums.
1. Select the MIDI submodule (9) from the Master/Global module.
2. Select MIDI Mix (1). The following screen will appear.
MIX C=01 Volume=127
zzzz zzzz zzzz zzzz
✱
Tip: Refer to the routing diagram on
page 217.