ESI ESI2000, Руководство по эксплуатации

Страница: 60 / 272

52
ESI Operation Manual
GAIN CHANGE
Amount: +00dB
+XXdb = Normalize
Where XX is the amount of gain needed to achieve normalization or full
level.
3. Set the amount of gain so that it matches the normalization
reading. Press ENTER to accept the selection. The display shows:
FADE secs samples
Size: 1.00 44096
Type:
Linear
4. We don’t want a fade in this example, so simply press ENTER to
affect the gain change.
The sample should now be at a higher volume. Note that you can use
the Digital Processing module, Undo (9) to cancel the effects of Gain
Change. Use this feature to further experiment with different Gain
Change settings.
5. Select Taper (1). Now let’s taper the end of the sample so that it
smoothly fades out instead of ending in a thump. The display
shows:
TAPER secs samples
Start: 0.00 00000
End: 1.00 44096
Size: 1.00 44096
6. Move the start point to about 0.70 seconds and press ENTER.
The display changes to:
TAPER
Start Amount: 0.00db
End Amount: -96db
Type: Linear
The Start and End amounts on lines two and three are already at the
correct settings. There will be no attenuation at the Start point, tapering
to full attenuation at the End point of the sample.