ESI ESI2000, Руководство по эксплуатации

Страница: 97 / 272

Master/Global
89
!
Caution: Drive 0 cannot be used since
the ESI uses this number for the floppy disk.
1. Emax II Import
The Emax II Import function allows you to import Presets, Samples or
entire Banks from the Emax II sampler and convert them into an ESI
bank. Data is imported into the ESI, from an Emax II formatted SCSI
device. Load time will be approximately twice that of the Emax II. There
are a few fundamental differences between the Emax II and the ESI. For
this reason a few parameters are ignored during the conversion process.
In most cases, however, the converted presets and samples should sound
and behave very similarly to the originals.
1. Activate Master/Global module.
2. Select Import (0), Emax II Import (1).
EMAX-II IMPORT
Select a Submodule
3. Select the desired import function. There are three options
available. Refer to the chart below.
0. Emax II SCSI Setup
Allows the ESI to specify the ID of the Emax II device.
1. Emax II Import Options
Asks you to confirm before erasing bank data.
2. Emax II Load
Allows you to browse through the Emax II SCSI device, select the
bank, presets or samples to import and start the import process.
An Emax II SCSI device is NOT mounted and accessed like a normal ESI
drive (the load and drive buttons will not access the Emax II drive).
Instead, it is accessed and operated using the Emax II import menus.
Only one Emax or Akai SCSI device can be known to the ESI at any
given time.
4. Press 0 on the keypad to select Emax II SCSI Setup. This step is
necessary for the ESI to recognize the Emax II SCSI device. The
display shows:
EMAX II SCSI SETUP
SCSI ID: SEARCH
TOSHIBA CD-ROM DRIVE
Select SEARCH or ID