ESI ESI2000, Руководство по эксплуатации

Страница: 39 / 272

Guided Tours
31
To Save a Bank to Disk:
1. Press the Save button. Position the cursor under the drive
number in line two. Select the disk drive using the data entry
control. Press ENTER.
2. Use the Data entry control to select an Empty Bank. Empty
banks are indicated as such, along with their bank number on line
three. Saving to a non-empty bank erases the bank that was previ-
ously saved there.
3. Press ENTER to save the bank. The display will revert to the preset
selection screen.
Loading a Bank from a Hard Disk
1. Press the Load button. The display says: Load Bank, and shows the
name and number of the current bank.
2. Select the desired bank . Use the Data Entry Control to scroll
through the available hard disk banks. Stop when you find the bank
you want.
3. Press ENTER .
• An alternate method of loading a hard disk bank is to press
Load, then type in the number of the bank using the numeric
keypad.
The display will show the current preset number and name.
The cursor will flash underneath the first digit. Start playing the
keyboard and adjust the master volume Data Entry Control for a
comfortable listening level.
To check out the various presets within the bank, read on.
Selecting Different Presets
The bank you just loaded contains several presets. To call up a new
current preset, use the up/down cursor buttons to position the cursor
under the preset number, then use the keypad underneath the display.
Note that leading zeroes must be entered for preset numbers (for ex-
ample, type 0, 0 and 2, not just 2, to call up preset 002). Now type the
number of the desired preset on the keypad. The entered preset number
these will replace the numbers indicated by the flashing cursor.
If you enter a number for which there is no preset, the display lists the
entered preset number followed by “Empty Preset.” Try again.
To scroll through the presets available in the bank, turn the Data Entry
Control. The various preset names will scroll on the lower display line.
When this line shows the desired preset, press ENTER to make that the
current preset. This is an alternative preset selection method.
Yet another method is to use the left and right cursor buttons to incre-
ment or decrement through the presets. This method allows you to
arrange your presets in the proper order, then access them sequentially
with a single press of a button.
When you’re ready to check out some more sounds, proceed.
✱
Tip: See Master/Global, Disk Utilities
and the SCSI section of this manual for
important information about hard disk
drives.
✱
Tip: Use the “Mount Drives” utility
(Master/Global, Disk Utilities, 1) whenever
an external SCSI device does not appear in
the list of available devices.