Danfoss VACON NX, Инструкция по применению

Страница: 41 / 360

Index Parameter Min Max Unit Default ID Description
2 = Programmable
3 = Linear with flux optim.
P2.6.4
(1)
Field weakening point 8.00 320.00 Hz 50.00 602
-
P2.6.5
(1)
Voltage at field weakening point 10.00 200.00 % 100.00 603
-
P2.6.6
(1)
U/f curve midpoint frequency 0.00 P2.6.4 Hz 50.00 604
-
P2.6.7
(1)
U/f curve midpoint voltage 0.00 100.00 % 100.00 605
-
P2.6.8
(1)
Output voltage at zero frequency 0.00 40.00 % Varies 606
-
P2.6.9 Switching frequency 1.0 Varies kHz Varies 601
-
P2.6.10
Overvoltage controller
0 2
-
1 607 0 = Not used
1 = Used (no ramping)
2 = Used (ramping)
P2.6.11 Undervoltage controller 0 2
-
2 608 0 = Not used
1 = Used
2 = Used (ramping to zero)
P2.6.12 Load drooping 0.00 100.00 % 0.00 620
-
P2.6.13 Identification 0 2/5
-
0 631 0 = No action
1 = Identification w/o run
2 = Identification with run
Only VACON
®
NXP:
3 = Encoder ID run
4 = No action
5 = ID Run Failed
Closed Loop parameter group 2.6.14
P2.6.14.1 Magnetizing current 0.00 2 x I
H
A 0.00 612
-
P2.6.14.2 Speed control P gain 1 1000
-
30 613
-
P2.6.14.3 Speed control I time 0.0 3200.0 ms 30.0 614
-
P2.6.14.5 Acceleration compensation 0.00 300.00 s 0.00 626
-
P2.6.14.6 Slip adjust 0 500 % 100 619
-
P2.6.14.7 Magnetizing current at start 0.00 I
L
A 0.00 627
-
P2.6.14.8 Magnetizing time at start 0 60000 ms 0 628
-
P2.6.14.9 0-speed time at start 0 32000 ms 100 615
-
P2.6.14.10 0-speed time at stop 0 32000 ms 100 616
-
AB296635287482en-000301 / DPD00903 | 41 Danfoss A/S © 2023.02
Local/Remote Control Application
VACON® NX All-in-One
Application Guide