Danfoss VACON NX, Инструкция по применению

Страница: 324 / 360

•
•
•
Signal Description
1=The drive is running and ready to release the reference
b3 Fault Active
0=No fault active
1=Fault IS active
b4 Coast Stop Not Active
0=Coast stop active
1=Coast stop NOT active
b5 Quick Stop Not Active
0=Emergency stop active
1=Emergency stop NOT active
b6 Switch On Inhibited
0=No Inhibit
1=The drive is out of fault and coast / quick stop state
b7 Warning
0=NO alarm
1=Alarm IS active
b8 Speed At Reference
0=Speed actual is NOT equal to speed reference
1=Speed actual is equal to speed reference
b9 Fieldbus Control Active
0=Fieldbus Control NOT active
1=Fieldbus Control active
b10 Speed Reference Reached or Exceeded
Indicate if speed actual is below the limit P2.4.16
0=Speed actual is below the speed limit
1=Speed actual is above the speed limit
b11 Not Used Reserved
b12 Drive Running
0=Drive is stopped
1=Drive is running
b13 Drive Ready
0=Drive is not ready
1=Drive is ready
b14 Not Used Reserved
b15 Not Used Reserved
10.633 Condition-based Monitoring
VACON
®
NXP offers Condition-based Monitoring to identify motor faults at an early stage. Stator Winding Monitoring, Vibration, and
Load envelope are supported in this application. Condition-based Monitoring is license protected. To make the Condition-based
Monitoring effective, buy a license key from a Danfoss supplier.
For more detailed information on the commissioning and use of Condition-based Monitoring, refer to the VACON
®
Condition-based
Monitoring Application Guide.
10.633.1 Introduction to Condition-based Monitoring
Benefits of installing the Condition-based Monitoring firmware are as follows:
Reduces unexpected downtime.
Optimizes drive or motor working conditions.
Eliminates unexpected halts in production.
Condition-based Monitoring regularly checks of the condition and performance of the machine when the drive is in operation, and
detects mechanical, motor, or application failures in advance. Corrective actions can be performed before the process or application
AB296635287482en-000301 / DPD00903 324 | Danfoss A/S © 2023.02
Parameter Descriptions
VACON® NX All-in-One
Application Guide