install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
Broadcast Pix
V8.5
1.5.2 Wiring the Slate 5016Gdd & 5016Ghh
1. Attach analog reference/blackburst. Run one wire from your sync generator to
the Router’s ‘Sync’ input, and then run a second wire from the Router’s ‘Sync’
output to the ‘Ref’ input on the Slate, as shown on the wiring diagram on the next
page.
2.
Connect BNC video cables between the Slate Cards and the Router, as follows:
On Switcher boards
On Router
A - SD only (right)
Input 16
B - SD only (right)
Input 15
D - HD or SD (center)
Input 14
E - HD or SD (left)
Input 13
On I/O board (center) On Router
S1 Output 16
S2 Output 15
S3 Output 14
S4 Output 13
3.
Attach the following video cables on the Router, if desired:
Inputs 1-12
to cameras, tape decks and other sources
Program, Output 1
to a program monitor and other program destinations
Preview, Output 2
to a preview monitor
Auxes, Output 3-8
to auxiliary outputs
4.
Attach three network cables (Cat 5) from the private Ethernet 10/100 switch to the
Broadcast Pix components, as follows:
From Hub
Any port
To workstation NIC 2, next to the USB ports
Any port
To control panel - either network connector
Any port
To Router ‘ENET’ connector
NOTE:
The workstation has two network connections, the above NIC1 and a 1GB NIC2. NIC2
connects the system to a “house” network, which is convenient for moving content into the system.
Do not move data through the private network hub, as it will affect system performance.
5.
Attach the RS-232 serial cable from the control panel to the Router’s serial input
labeled ‘SERIAL’. See section A.6 for pin-out.
6.
Attach the Workstation’s VGA monitor(s), mouse and keyboard.
7.
Plug in power to the workstation, Router and control panel.
8.
See Section 1.5.8 to set the inputs on the Router for name and timing.
1.5.2
On I/O board (left) On Router
S5 Output 12
S6
Output 11
S7 Output 10
S8 Output 9