install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
Broadcast Pix
V8.5
7.7.3 Setting Camera Numbers for Hitachi Camera Control
After installation is complete, you need to set the address of each Pan/Tilt head. All
Eagle Pan/Tilt heads are set at the factory to have the addresses remotely
programmed. If you have trouble with anything in this section, go to the Display
Devices Operations and Instruction Manual and be sure your head is set to remote
address control.
To assign numbers to each camera:
1.
Create a Broadcast Pix show, as described in section 3.
2.
Add camera control to that show, as described in section 7.8.
3.
Decide what address each Pan/Tilt Head is going to be. In order to set the
address of the head, the panel sends out a command to all connected heads. So
in order to get the correct address to just one head, all of the other heads not
being programmed need to be powered down, by unplugging them.
4.
On the control panel, press the
[Hitachi Camera Control]
device button, and
then the PixPad will show 9 Cameras. For this operation it makes no difference
which one you press, so press any one of the nine.
5.
On the next PixPad press
[Settings]
. On the next PixPad press the
[Cam Cntrl]
.
On the next PixPad press
[Next]
. On the next PixPad press
[Next]
, and you
should arrive at the following PixPad:
7.7.3