WorldCast Equinox - Release 3.1 - user manual
– 07/2011
Page 66
Whiterock Business Park - 729 Springfield Road - Belfast BT12 7FP - Northern Ireland
Tel.: +44 28 9067 7200 | Fax: +44 28 9067 7201 | http://www.aptcodecs.com
Note:
When using 24 bit linear audio the onboard processor is running at almost full capacity
– using
the front panel or connecting to the unit using the NMS may cause glitching in the audio. Using a
larger packet size will reduce the effect of this.
Note:
If additional TX routes are enabled (multiple unicast) and the user then decides to have a mul-
ticast connection, ensure that the multicast and any of the multiple unicast routes are not transmitting
to the same unit. If this happens, audio glitching could happen.
5.6.3. Clear Profiles
Select this option to clear all of the IP speed dials to a default state. Using this option will erase all of the stored
speed dials so it should be used with care. The following confirmation screen will be displayed: -
Clearing IP speed dials
To confirm enter 123 on the keypad and all of the entries will be reset to the following state: -
Name: Free
IP Address: 192.168.100.000
Transmit Multicast/Unicast: Unicast
IP Port Number: 5000
Transmitter: Disabled
Quality of Service: 0
Packet Size: 128
Transmit Hardware Compatibility: APT (use 3
rd
party if connecting to a WorldNet Tokyo)
Additional Transmission Routes: Disabled
Receiver: Disabled
Receive Multicast/Unicast: Unicast
Receive Buffer Latency: 50mS
Autosense: Disabled
Receive Hardware Compatibility: APT (use 3
rd
party if connecting to a WorldNet Tokyo)
5.6.4. FEC
Use this option to enable/disable FEC (Forward Error Correction)
5.6.5. FEC Stream port
If port + 6 is selected:
Clear Directory Setup
All Dir. will be Lost!
Press 123 to Confirm!
Warning:
IP aux will use port+2
IP remote status will
use port +4
Press any key to contin-
ue
