Section 4. Program Operation
EMERGENCY ANI ACK ENABLED?
[N] Yes No
Figure 4-12. Emergency ANI ACK Enable/Disable Window
After making your selection, press the
ESC
key to return to the CPS main menu.
2.
ANI Destination Address
To set the position’s ANI address, select Destination from the ANI menu.
The Model 4010 has two ANI addresses: a primary and a secondary. Normally the
primary address is used to select a group of consoles, while the secondary address is
used to select an individual console within the group. If only a single console is
involved, the secondary address is not used. For a group call, the primary addresses
should be set the same for all of the consoles in the system.
Enter the primary address by entering up to six DTMF digits in the primary address
field and pressing
ENTER
. Enter the secondary address in the same manner. The
following characters are valid DTMF digits: 0123456789ABCD#*.
The timeout period is the time window between the detection of a valid address and
the last DTMF digit accepted. If the calling unit has automatic ANI calling, 1 or 2
seconds should be sufficient. If the calling unit uses a manual keypad to enter the ANI
address, 5 seconds is the normal timeout. Enter a timeout period between 1 and 10
seconds and press
ENTER
.
Note:
During operation, new ANIs will only be recognized after the time period has
elapsed after the previous ANI.
E. Display Operation
The Display Operation function sets the mode of operation for the console display. Select
E
for edit from the MAIN menu and then select
P
to display the next menu. Next, select
E
and
the DISPLAY OPERATION menu will be displayed. Select the desired mode for the console
display and press
ENTER
.
F. Miscellaneous
The Miscellaneous function allows the following parameters to be set: audio source for
“soft” transmit keys, the display mode of instant select keys, the duration of the Call lamp
after the received audio stops, and selection of the dynamic mic device.
Select
E
from the MAIN menu and then select
P
to display the next menu. Next, select
F
to
display the MISCELLANEOUS SETTINGS menu.
Select option
A
to set the audio source for “soft” transmit keys and display the AUDIO
SOURCE menu.
025-9229C.1
4-13
Summary of Contents for 4010
