Parameters
Converting Parameter Files via Smart View
Parameter files of the same type can be up- or downgraded (converted). As many parameters as possible will
be taken over.
•
Parameters, that are newly added, will be set to default.
•
Parameters, that are not included in the target file version, will be deleted.
In order to convert a parameter file please proceed as follows:
•
In case
Smart View
is not in operation – start this software.
•
Open a parameter file or load the parameters from a device that should be converted.
•
Make a backup of this file at a fail safe place.
•
Choose »Save as« from menu »File«.
•
Enter a new file name (in order to prevent overwriting the original file).
•
Choose the new file type from drop down menu »File Type«.
•
Confirm the security check by clicking on »yes« if and only you are sure that the file conversion should
be executed.
•
In tabular form the modifications will be shown as follows.
Added parameter:
Deleted parameter:
Page 226
EN MRM4 01/11
Summary of Contents for MRM4
