Woodward MRM4, Manual

Page: 141 / 460

Acknowledgments
As long as you are within the parameter setting mode, you cannot
acknowledge.
In case of a fault during parameter setting via the operating panel, you must
first leave the parameter mode by pressing either push-button »C« or »OK«
before you may access to menu »Acknowledgments« via push-button.
Manual Acknowledgment
•
Press the C-Button at the panel.
•
Select the item to be acknowledged via the Softkeys:
•
Binary output relays;
•
LEDs;
•
SCADA;
•
a pending trip command; or
•
all (above) mentioned items at once.
•
Press the Softkey with the »Wrench-Symbol«.
•
Enter your password.
Manual Acknowledgment via Smart View
In case Smart View is not running – please start it.
•
If the device data were not yet loaded – select »Receive Data From The Device« from menu »Device«.
•
Double click on icon »Operation« in the navigation tree.
•
Double click on icon »Acknowledgment« within the operation menu.
•
Double click the entry within the pop-up that is to be acknowledged.
•
Press the button »Execute immediately«.
•
Enter your password.
External Acknowledgments
Within the menu [Ex Acknowledge], you can assign a signal (e.g. the state of a digital input) from the assignment
list that:
•
Acknowledges all (acknowledgeable) LEDs at once;
•
Acknowledges all (acknowledgeable) binary outputs at once; or
•
Acknowledges all (acknowledgeable) SCADA-signals at once.
EN MRM4 01/11 Page 141