Woodward MRM4, Manual

Page: 122 / 460

Smart View
Setting up the Connection PC - Device
Set-up a Connection via Ethernet - TCP/IP
Establishing a connection via TCP/IP to the device is only possible if your
device is equipped with an Ethernet Interface (RJ45).
Contact your IT administrator in order to establish the network connection.
Part 1: Set the TCP/IP Parameters at the panel (Device)
Call up the menu »Device parameter/TCP/IP« at the HMI (panel) and set the following parameters:
•
TCP/IP address;
•
Subnetmask; and
•
Gateway.
Part 2: Setting the IP address within Smart View
•
Call up the menu Settings/Device Connection within Smart View.
•
Set radio button Network Connection.
•
Enter the IP-Address of the device that should be connected.
Set-up a Connection via Serial Interface under Windows 2000
After installation of the software, the »Connection PC/Notebook to the Device« has to be configured once, so
that you are able to read device data or re-write them into the device by means of the software Smart View.
For connection of your PCs/notebooks with the device you need a special
zero-modem cable (no serial cable!/please refer to chapter »Zero Modem
Cable«).
If your PC/notebook does not have a serial interface, you need a special
USB-to-serial-adapter. Only if the USB-to-serial-adapter is correctly
installed - aided by the provided CD – the communication with the device
can be established. (see next chapter).
The connection Notebook/PC to the device must not be
protected/encrypted via a smartcard.
If the network connection wizard asks you, to encrypt the connection via a
smartcard or not, please choose »Do not use the smartcard«.
Setting up/Configuring the connection
•
Connect your PC/notebook with the device via a zero-modem cable.
Page 122 EN MRM4 01/11