Woodward MRM4, Manual

Page: 224 / 460

Parameters
•
Setting Group Parameters: »Set1..4« : The protection parameters that you set within a parameter set are
only valid, if the parameter set where you set them is switched to active.
Setting Groups
Setting Group Switch
Within the menu »Protection Para/P-Set Switch« you have the following possibilities:
•
To set one of the four setting groups active manually;
•
To assign a signal to each setting group that sets this group to active; or
•
Scada switches the setting groups.
Setting Group Switch
Manual Selection Via Input Function
(e.g. Digital Input)
Via Scada
Switching Options Switch over, if another
setting group is chosen
manually within the menu
»Protection Para/P-Set
Switch«
Switch over not until the
request is clear.
That means, if there is
more or less than one
request signal active, no
switch over will be
executed.
Switch over if there is a
clear Scada request.
Otherwise no switch over
will be executed.
The description of the parameters can be found within chapter System
Parameters.
Setting Group Switch via Smart View
In case Smart View is not running – please start it.
•
If device data has not been loaded yet – click »Receive Data From The Device« in menu »Device«.
•
Double click the »Protection Para« icon in the navigation tree.
•
Double click the »P-Set Switch« within the protection parameters.
•
Configure the Setting Group Switch respectively choose an active set manually.
The description of the parameters can be found within chapter System
Parameters.
Copying Setting Groups (Parameter Sets) via Smart View
Setting groups can only be copied if there are no implausibilities (no red
question mark).
Page 224 EN MRM4 01/11