Toshiba DP120F, Service Manual

Page: 550 / 706

DP120F/DP125F Removal/Replacement 8-130 March 2000 © TOSHIBA TEC
3. Adjustment and Setting
3.1 Paper Pickup Solenoid Gap
Adjust the paper pickup solenoid gap to pick the recording paper up properly. When the paper
pickup roller assembly (bypass tray/paper tray/optional paper tray) or paper pickup solenoid
(bypass tray/paper tray/optional paper tray) is removed, the paper pickup solenoid gap proce-
dure must be performed.
3.1.1 Paper Pickup Solenoid (Bypass Tray) Gap
Adjustment
Install the paper pickup solenoid so that the gap between the claw of the clutch spring and the
armature of the paper pickup solenoid becomes 0.8 +0.2/-0.2mm while pulling the armature of
the paper pickup solenoid by the solenoid.
WARNING: Turn off the power and disconnect the power cord from the outlet.
(1) Disconnect the Telephone line cord.
(2) Remove the developer assembly with drum unit.
(3) Remove the rear side frame. (Refer to "2.4.3 Rear Side Frame.")
(4) Remove the front cover assembly. (Refer to "2.1.6 Front Cover.")
(5) Remove the right side cover. (Refer to "2.1.7 Right Side Cover.")
(6) Turn the paper pickup roller until the claw of the clutch spring touches the armature of the
paper pickup solenoid.
(7) Loosen the one set screw of the paper pickup solenoid, insert the 0.8mm thickness gauge
between the clutch spring claw and the armature. Then tighten the one set screw of the
paper pickup solenoid.