TOHATSU BFT 250A, Service Manual

Page: 91 / 639

3-33
dummyhead dummyhead
MAINTENANCE
EMERGENCY STOP SWITCH
INSPECTION
Make sure that the clip [1] is set at the emergency stop
switch.
Start the engine and idle the engine in neutral.
The engine should stop when the clip is removed.
If it does not, replace the emergency stop switch.
Set the clip [1] to the emergency stop switch.
Start the engine and idle the engine in neutral.
The engine should stop when the switch is pushed.
If it does not, replace the emergency stop switch.
POWER TRIM/TILT INSPECTION
Set the swivel case to the uppermost position.
Make sure that the power trim/tilt has no ATF leaks.
If the ATF leaks, replace or repair the faulty part(s)
(page 19-19).
SHIFT CONTROL CABLE INSPECTION/
ADJUSTMENT
Check the shift control cable for damage or corrosion.
Replace if necessary (page 20-3).
Check the shift control cable connected parts for
damage or loose fitting.
Tighten the loose fitting or replace if necessary (page
20-3).
Start the engine.
Check the shift control cable for smooth operation.
Check that each gear shifts properly when the shift
lever is moved to each position ("F" (Forward), "R"
(Reverse), "N" (Neutral)).
Stop the engine.
Adjust or replace if necessary (page 20-3).
[1]
[1]