TOHATSU BFT 250A, Service Manual

Page: 300 / 639

9-14
dummyhead dummyhead
STARTING SYSTEM
Install the brush holder [1] on the armature [2].
Apply grease to the armature shaft.
Install the rear bracket [1] as shown.
Apply the water resisting sealant (Sumitomo 3M
Padding Sealer #8533 or equivalent) to the seat of each
screw [2].
Install and tighten the screws (5 x 8 mm) to the
specified torque.
Check the inner wall of the yoke [1] for foreign material
and install the armature/rear bracket assembly [2] to the
yoke.
• Install the armature/rear bracket assembly by
aligning the grommet [3] with the cutout [4] in the
yoke.
[1]
[2]
TORQUE: 2.5 N·m (0.25 kgf·m, 1.8 lbf·ft)
[2]
[1]
[2]
[1]
[3]
[4]