TOHATSU BFT 250A, Service Manual

Page: 583 / 639

19-21
dummyhead dummyhead
TRIM/TILT
Remove socket bolts A (8 x 84 mm) [1], two socket
bolts B (8 x 23 mm) [2], and the pump [3]. Remove the
five O-rings [4] and orifice collar [5] from the cylinder.
Remove the reservoir valve [6], pin [7], and steel ball [8]
from the cylinder.
Remove the filter [9], valve seat [10], and O-ring [11].
Remove the internal circlip [1] and manual valve [2]
from the pump [3].
Check the manual valve and O-ring for deterioration,
wear, and damage.
Replace the manual valve with a new one if necessary.
Hold the cylinder [1] in a vise [2] with a shop towel or
soft jaws as shown.
Do not tighten the vise excessively, as it can damage
the cylinder.
• Make sure the right and left piston rod B are fully
extended.
• Do not push piston rod B into the trim cylinder.
Remove the rod guide [1] using the special tool as
shown.
[1]
[5]
[2]
[4]
[3]
[6]
[7]
[8]
[9] [10]
[11]
[1]
[2]
[3]
[1]
[2]
TOOL:
Pin wrench, 4 mm [2]
07SPA-ZW1020A
[2]
[1]