TOHATSU BFT 250A, Service Manual

Page: 386 / 639

14-18
dummyhead dummyhead
CYLINDER HEAD
Make sure the No. 1 piston TDC marks [1] on both
timing belt driven pulleys and the pointers [2] on the
timing belt covers are aligned when the groove of the
crankshaft pulley lines up with the pointer on the
crankcase.
If the alignment marks do not align, remove the timing
belt and repeat the timing belt installation steps.
Install the timing belt covers [1] and tighten the four
timing belt cover bolts [2].
Set the harness clip [3] and main wire harness [4] to the
timing belt covers.
• Route the wire harness properly (page 2-19).
Install the following:
– Alternator belt (page 7-5)
– Throttle body (page 5-71)
RIGHT SIDE:
LEFT SIDE:
[1]
[2]
[1]
[2]
RIGHT SIDE:
LEFT SIDE:
[1]
[2]
[4]
[3]
[3]
[2]
[4]
[1]