TOHATSU BFT 250A, Service Manual

Page: 570 / 639

19-8
dummyhead dummyhead
TRIM/TILT
Store the power trim/tilt assembly [1] vertically with the
upper cylinder bushing section [2] facing up after
removal. Never store the power trim/tilt with the motor
facing up or with the lower cylinder bushing section [3]
facing up.
EXPLODED VIEW
[2]
[3]
[1]
Storage
position:
MOTOR CODE BUSHING
WIRE HARNESS CLIP
TRIM ANGLE SENSOR
BOLT
(6 x 20 mm) [2)
UPPER CYLINDER
BUSHING (2)
POWER TRIM/TILT
WASHER (10 mm)
LOWER CYLINDER
BUSHING (2)
SWIVEL CASE
UPPER CYLINDER PIN
SELF-LOCKING NUT
(10 mm)
BOLT (10 x 235 mm)
E-RING
(15 mm) (2)
LOWER CYLINDER
COLLAR
BOLT (6 x 23 m) (2)
TILTING SHAFT
WASHER (7/8 in)
34 N·m (3.5 kgf·m, 25 lbf·ft)
ANODE
R. STERN BRACKET
L. STERN BRACKET
34 N·m (3.5 kgf·m, 25 lbf·ft)
SELF-LOCKING NUT
(7/8-14 UNF mm)
WAVE WASHER
(26 mm) (2)
SWIVEL CASE
BUSHING (2)]
GROUND
TERMINAL
WASHER (25 mm)
SELF-LOCKING NUT (25 x 2.0 mm)