TOHATSU BFT 250A, Service Manual

Page: 309 / 639

10-3
dummyhead dummyhead
OTHER ELECTRICAL
FUSE RELAY JUNCTION BOX
REMOVAL/INSTALLATION
REMOVAL
Disconnect the battery negative (–) cable, then the
positive (+) cable from the battery.
Remove the engine cover.
Remove the following:
– Fuse/relay junction box terminal bolts (6 x 22 mm)
[1] (three)
– Power tilt relay cable [2]
– Starter cable 1 (+) [3]
– ACG cable [4]
– Fuse/relay junction box mounting bolts (6 x 20 mm)
[5] (four)
– Fuse/relay junction box 10P connector [6]
– Fuse/relay junction box 8P connector [7]
– Fuse/relay junction box 23P connector [8]
– Fuse/relay junction box [9]
Remove the fuse/relay junction box cover [10] from the
fuse/relay junction box.
Installation is in the reverse order of removal.
• Route the wire harness properly (page 2-19).
TORQUE:
Fuse/relay junction box mounting bolt:
5.0 N·m (0.51 kgf·m, 3.7 lbf·ft)
Fuse/relay junction box terminal bolt:
8.5 N·m (0.87 kgf·m, 6.3 lbf·ft)
[9]
[8]
[10]
[6]
[4]
[3]
[2]
[1]
[7]
[5]