TOHATSU BFT 250A, Service Manual

Page: 164 / 639

5-42
dummyhead dummyhead
FUEL SYSTEM
DTC 141-1, 141-2 (ECT SENSOR 3 (EMT SENSOR 2) VOLTAGE IS TOO LOW
OR TOO HIGH)
DTC 141-1 (ECT SENSOR 3 (EMT SENSOR 2)
VOLTAGE IS TOO LOW)
1. Symptom reproduction test
Turn the combination switch OFF.
Disconnect the EMT sensor 2 2P connector
,
ECM connector A , ECM connector B ,
joint connector 1 and then reconnect them.
Clear the DTC (page 5-6).
• Continue the procedure if the DTC does not
clear.
Turn the combination switch ON.
Measure the EMT sensor 2 voltage using the HDS.
Is the measurement within 0.08 – 4.92 V?
YES – Temporary failure (code does not
reappear).
NO – GO TO STEP 2.
2. EMT sensor 2 signal line short circuit inspection
Turn the combination switch OFF and disconnect
the EMT sensor 2 2P connector
.
Turn the combination switch ON.
Measure the voltage between the EMT sensor 2 2P
connector
main wire harness side No.1 (Red)
terminal and engine ground.
Is the measurement within 4.75 – 5.25 V?
YES – Replace EMT sensor 2 with a new one and
recheck.
NO – Repair short in the main wire harness
between the ECM and EMT sensor 2. If
the main wire is correct, replace the ECM
with a new one and recheck.
Bl: Black
Y: Yellow
Bu: Blue
G: Green
R: Red
W: White Br: Brown
O: Orange
Lb: Light blue
Lg: Light green
P: Pink
Gr: Gray
TOH2
ECM
ECT SENSOR 3
(EMT SENSOR 2)
R
30
G
2
5 V
SG2
25
R
G
1
1
JOINT CONNECTOR 1
3
EMT SENSOR 2 2P CONNECTOR
MAIN WIRE HARNESS SIDE
TOH2
(Red)