TOHATSU BFT 250A, Service Manual

Page: 292 / 639

9-6
dummyhead dummyhead
STARTING SYSTEM
NEUTRAL SWITCH REMOVAL/
INSTALLATION
Remove the electric parts case (page 10-4).
Remove the bolt (6 x 14 mm) [1] and neutral switch
bracket [2] from the crankcase.
Remove the neutral switch plate [3] and neutral switch
[4] from the bracket by removing the neutral switch nut
(20 mm) [5].
Installation is in the reverse order of removal.
When installing the neutral switch bracket, align its hole
[6] with the boss of the crankcase.
Make sure the click spring roller [1] is in the shift arm
groove [2] and assist spring tip [3] is connecting the
neutral switch [4] is pushed in with the shift lever in the
neutral position.
Make sure the assist spring tip does not contact the
neutral switch when the shift lever is in either forward or
reverse.
Install the electric parts case (page 10-4).
STARTER MOTOR DISASSEMBLY/
ASSEMBLY
DISASSEMBLY
Remove the nut [1] by pulling off the terminal cover [2]
and disconnect the motor wire [3] from the M terminal.
TORQUE:
Neutral switch nut:
2.5 N·m (0.26 kgf·m, 1.8 lbf·ft)
[1]
[3]
[6] [5]
[2]
[4]
[1]
[2]
[4]
[3]
[1]
[3]
[2]