TOHATSU BFT 250A, Service Manual

Page: 589 / 639

19-27
dummyhead dummyhead
TRIM/TILT
Apply ATF to a new oil seal [1].
Holding the oil seal in the shape of a "U" with your
fingers, install it in the lower groove in the rod guide [2],
taking care not to damage the oil seal.
Apply ATF to a new dust seal [3].
Holding the dust seal in the shape of a "U" with your
fingers, install it in the upper groove in the rod guide,
taking care not to damage the dust seal.
Apply ATF to a new O-ring [4] and install it on the rod
guide.
Pour fresh ATF in the right and left trim cylinder
chambers up to the top of the trim cylinder chamber.
Install the rod guide [1] on piston rod B [2].
Extend the piston rod B fully and hold it in that position.
Set one piston rod B in the left cylinder chamber and
one in the right cylinder chamber.
Do not install either piston rod B by pushing it into the
trim cylinder.
Holding each piston rod B in place, loosely tighten the
rod guides on the cylinders.
Do not install either piston rod B by pushing it into the
trim cylinder.
[3]
[1]
[2]
[4]
[1]
[3]
[1]
Push in at an angle.
Hold in the shape "U".
Push in by deforming
it slightly.
[4]
[2]
Pour slowly up to the top
of the trim cylinder
chamber
[2]
[1]