TOHATSU BFT 250A, Service Manual

Page: 581 / 639

19-19
dummyhead dummyhead
TRIM/TILT
Position the ground cable [1] against the stopper [2] of
the lower mount center housing [3], and then install and
tighten the screw (6 x 8 mm) [4].
Install the swivel case (page 19-9).
POWER TRIM/TILT DISASSEMBLY/
ASSEMBLY
DISASSEMBLY
• Do not disassemble the pump. If it is faulty, replace it
as an assembly.
• Do not use a shop towel, cloth, or gloves during
removal.
• Use the recommended automatic transmission fluid
(ATF).
Recommended ATF: Honda Genuine Automatic
Transmission Fluid (ATF), DEXRON
® or equivalent.
• Do not reuse the drained ATF.
• Do not tighten the vise excessively when holding the
power trim/tilt in a vise during operation.
• Clean the removed parts in fresh ATF, and blow
each port of the parts with compressed air. Set the
parts neatly in a suitable container with care not to
contaminate them with dust and dirt.
• Do not reuse O-rings and oil seals.
• Take care not to damage the sliding surface of the
piston rod when removing them.
Remove the power trim/tilt (page 19-6).
Operate the power tilt motor until the each rod reach the
fully extended position (page 19-31).
Remove the oil tank cap [1], and drain the ATF from the
oil tank.
Do not drain the ATF by pushing the piston rod in.
Loosely install the oil tank cap on the oil tank.
[3]
[2]
[1] [4]
[1]