Terumo CAPIOX EBS Circuit with X coating, Instructions For Use Manual

Page: 10 / 177

Precaution for storage
・
Do not use if the unit package or the product has been
damaged or soiled. Use it immediately after opening the
unit package and dispose of it safely after use.
・ Spare pack of CAPIOX EBS Circuit should be available for
emergency exchange.
・
Do not allow solvents such as alcohol, ether, acetone, etc.
to come in contact with the device as it may cause
damage to the device.
・
Use CAPIOX SP Pump Console SP-101 and CAPIOX
Centrifugal Pump Controller SP-200 according to the
instructions described in the Instructions for Use.
・
Set this product correctly with a holder or a drive motor.
・
The centrifugal pump of this product contains a magnet.
Therefore, keep away from metals and magnetic tapes.
・
Use this product at flow rate lower than the maximum 7
L/min.
・
Do not exceed the maximum pump speed of 3000rpm.
Otherwise, it would increase blood damage and cause
breakage of this product and leakage.
・
Do not install or remove the pump until the motor has
completely stopped.
・
All procedures must be aseptically performed.
・
Perform priming procedure using crystalloid solution which
contains no blood, plasma and/or blood derived products.
・
For monitoring temperature, Y.S.I. 400 Series manufactured
by Measurement Specialties Inc. can be used. Use it with
its exclusive cable.
•
In case of using CAPIOX EBS Cannula Kit, follow
instructions described in the Instructions for Use.
・
Water pressure at the heat exchanger inlet should
not exceed 196kPa (2kgf/cm 2 ). Pressure greater than
196kPa
(2kgf/cm 2 ) may cause leaks or damage to the device.
・
Pay attention not to wet the device. Avoid direct sunlight,
extreme temperature and humidity for storage.
PRECAUTION