Terumo CAPIOX EBS Circuit with X coating, Instructions For Use Manual

Page: 14 / 177

Priming procedure
・
This product should be primed with crystalloid solution
which contains no blood, plasma and/or blood
derived products.
・
In case of adding blood or plasma, etc. in the priming
solution, after priming, follow the procedure below.
・
Infuse blood or plasma, etc. from the priming line.
・
At the same time, remove the clear priming solution
from the sampling line to replace in the circuit.
1. Set the circuit at the lower position than the oxygenator.
2. Remove the protection cap from the plastic spike after closing
the clamp on the priming line. Then connect the plastic spike to a
bag or a bottle filled with priming solution.
3. After confirming that the 3-way stopcock on the priming line is
open, release the clamp.
4. Fill the tubing circuit except the centrifugal pump and the
oxygenator with priming solution.
It may take more time for priming if a large quantity of
bubbles remains in the circuit.
5. Fill the oxygenator and the centrifugal pump with priming
solution.
6. After the circuit is fully primed or almost fully primed,
pull out the
handle of the exclusive holder (XX
*
EB04) (Figure 9).
7. Unlock the rotation of the exclusive holder (XX
*
EB04) (Figure 10)
and rotate the whole holder 90 degrees (Figure 11).
Figure 9
Figure 10
Figure 11
・
After the rotation, lock the rotation, and make sure
that the holder is fixed.
・ When rotating 90 degrees, the tube must be put on
the holder for rotation not to fold the circuit
(Figure 12).
・
Pay attention to prevent the tubing from tucking in
during rotation.
Figure 12
CAUTIONS
CAUTION
CAUTIONS