Set It Up and Get It Running 2-3
Plug It In and Turn It On
Make sure the power switch is off.
The power switch is on the back of the printer. Press the switch down to be sure it is off. Plug
the female end of the cord to the power connector on the back of the printer under the power
switch. Plug the male end into an AC outlet.
Turn on the power switch.
All four lights on the control panel come on for a few seconds. The print head moves to its
home position on the left, if it’s not already there. Three lights go out. The fault light stays on.
The LCD should say
Fault : Paper Out
The liquid crystal display on the front panel shows this message until paper is loaded.
If the printer did not come on ..
Check the AC outlet with another appliance.
If the printer beeps ...
If the printer emits a series of short beeps, something is wrong. Note the number of beeps and
call for service.
