Parameterizing motor data
Operation manual POSIDYN® SDS 5000
ID 442289.06
WE
KEEP
THINGS
MOVING
37
5
5.3
Direct entry in the parameters
The specifications of motors which do not have an electronic nameplate and cannot be selected in the
configuration assistant must be entered in the parameter list (e.g. motors of other manufacturers and special
motors). Depending on the motor type and the type of control, different parameters must sometimes be used.
Information
In control type
0:V/f-control
, no current or torque limitation occurs. Also connection to a rotating
motor is not possible (capture).
Direct entry of the motor data
1. Call up the configuration wizard in POSITool.
2. Continue up to step 5 motor selection.
3. Select a motor similar to your motor from the list of motors.
4. Close the assistant.
5. In POSITool select the parameter list.
6. Set the required control type in
B20 Control type
.
7. Enter in
B06 Motor data 1: User defined
.
8. Now edit the following parameters
:
-
B02 EMC constant
(only for servo motors)
-
B05 commutation offset
(only for servo motors)
-
B10 Motor pole
-
B11 Nominal motor output
-
B12 Nominal motor current
-
B13 Nominal motor speed
-
B14 Nominal motor voltage
(only for asynchronous motors)
-
B15 Nominal motor frequency
(only for asynchronous motors)
-
B16 cos phi
(only for asynchronous motors)
-
B17 M0
(only for servo motors)
-
B52 Stator inductance
-
B53 Stator resistance
-
B54 Leakage factor
(only for asynchronous motors)
-
B55 Magnetic saturation coefficient
(only for asynchronous motors)
-
B62 Moment of inertia
-
B73 Stat. friction moment
and
-
B74 Dyn. friction moment
for an optimized i
2
t-model
9. In parameter
B00 motor type
, you can also enter the type designation (max. 16 characters).
10. Go online and transfer the settings to the inverter.
11. Save the settings with
A00 Save values
.
The motor data and control type are correctly entered.
Summary of Contents for POSIDYN SDS 5000
Page 194: ...Notes WE KEEP THINGS MOVING ...
